직접 메탄올 연료전지를 위한 술폰화 폴리스티렌/테플론 복합막 제조 및 특성연구
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국막학회
ㆍ수록지정보 : 멤브레인 / 14권 / 2호
ㆍ저자명 : 김정훈, 신정필, 박인준, 이수복, 서동학
ㆍ저자명 : 김정훈, 신정필, 박인준, 이수복, 서동학
한국어 초록
술폰화 폴리스티렌/테플론(Polystyrene/Teflon, 이하 'PS/PTFE'로 칭함) 복합막을 제조하여 직접 메탄을 연료전지용 막에 관한 특성을 조사하였다. 복합막은 다음과 같이 제조되었다. 먼저 다공성 테플론 필름에 styrene 단량체와 가교제인 diviny benzene (이하 'DVB'로 칭함)의 비율을 달리하면서, 개시제 2,2'-azobis(isobutylonitlie) (AIBN)와 함께 함침시킨 후 열을 가해 폴리스티렌/테플론 복합막을 제조하였다. 그 후 술폰화제인 chlorosulfonic acid와 1,2-dichloroethane혼합용액을 사용하여 술폰화된 복합막을 제조하였다. 제조된 복합막의 술폰화 전과 후의 물리화학적 구조는 ATR-FTIR, SEM, THF 및 물에 대한 함유율, 이들의 이온교환량을 통하여 확인하였다. 이러한 결과로부터 스티렌/디비닐벤젠의 비율에 따라 복합막이 성공적으로 제조되었음을 확인하였다. 또한 가교제인 디비닐벤젠의 함량이 높을수록, 가교도가 증가하여 물 및 THF에 대한 함유율이 감소하였다. 이온전도도, 메탄올투과도를 조사한 결과, 디비닐벤젠의 함량 증가와 함께 이온전도도는 감소하였으며, 메탄올 투과도가 감소하였다. 제조된 술폰화된 폴리스티렌/테플론 복합막은 Nafion(R) 과 비교할 만한 높은 이온 전도도(0.11∼0.08 S/cm, 25℃)를 보이면서 훨씬 낮은 메탄올 투과도(6.6×10-7∼1.3×10-7 cm2/s)를 나타내었다. 이러한 결과들은 본 연구에서 개발된 복합막이 직접 메탄올 연료전지에 적용될 가능성이 높다는 것을 보여준다.영어 초록
For the application of direct methanol fuel cell (DMFC), sulfonated polystyrene/teflon (PS/PTFE) composite membranes were developed by changing monomer ratio of styrene and DVB. The composite membranes were prepared as follows: first, the monomer mixtures consisting of styrene, divinyl benzene and AIBN were impregnated in porous PTFE film and then, polymerized under 80℃ to give PS/PTFE membranes. Finally, the membranes were reacted with chlorosulfonic acid in 1,2-dichloroethane to give the sulfonated composite membranes. The measurements of ATR-FTIR, SEM, solvent uptake test and ion exchange capacity (IEC) were done for the resulting membranes before or after sulfonation, respectively, which showed the composite membranes with proper crosslinking degree and sulfonic acid content were prepared well as a function of styrene/DVB ratio. ion conductivity and methanol permeability were studied for the sulfonated membranes. It was found that with decreasing the ratio of styrene/DVB, methanol permeability decreased from 6.6×10-7∼1.3×10-7 cm2/s, which are much lower values than that of Nafion(R)117(1.02×10-6 cm2/s). Under the same monomer condition, ion conductivity decreased from 0.11 S/cm (25℃) to 0.08 S/cm (25℃), which are similar or a little higher values compared with Nafion(R)117 (1.02×10-6 cm2/s, 0.0824 S/cm). These two results confirmed the composite membranes prepared could be applied successfully to DMFC.C.참고 자료
없음"멤브레인"의 다른 논문
- 가교된 폴리비닐알콜 복합막을 이용한 불화에탄올/물 혼합용액의 투과증발분리 특성7페이지
- PU/PDMS 막을 이용한 증기투과공정에 의한 물로부터 휘발성 유기화합물 제거9페이지
- 광촉매 반응과 침지형 정밀여과를 이용한 자연산 유기물의 제거8페이지
- 중공사막에서의 물질전달 특성에 관한 연구7페이지
- NBR-Clay 하이브리드 막의 제조 및 물성10페이지
- 폴리설폰 필름의 형상 및 방사성 오염물 채취에 있어 용매처리의 효과6페이지
- 양이온교환용 PVA/PAM/Zirconium phosphate 막의 제조9페이지
- Pore-filled PVDF 이온교환막의 제조 및 응용9페이지
- 열분해성 그룹이 도입된 폴리이미드로부터 유도된 탄소분자체막의 수소 분리 특성9페이지
- 특허정보분석을 통한 해외 인공피부 기술동향14페이지