Reaction-Bonded Al2O3 Ceramics Using Oxidation of Al Alloy Powder
(주)코리아스칼라
- 최초 등록일
- 2016.04.02
- 최종 저작일
- 2014.05
- 7페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국재료학회
ㆍ수록지정보 : 한국재료학회지 / 24권 / 5호
ㆍ저자명 : Lee, Hyun-Kwuon
영어 초록
Fabrication of reaction-bonded Al2O3 (RBAO) ceramics using Al-Zn-Mg alloy powder was studied in order to improve traditional RBAO ceramic processing using Al powder. The influence on reaction-bonding and microstructure, as well as on physical and mechanical properties, of the particulate characteristics of the Al2O3-Al alloy powder mixtures after milling, was revealed. Variation of the particulate characteristics of this Al2O3-Al alloy powder mixture with milling time was reported previously. To start, the Al2O3-Al alloy powder mixture was milled, reaction-bonded, post-sintered, and characterized. During reaction-bonding of the Al2O3-Al alloy powder mixture compacts, oxidation of the Al alloy took place in two stages, that is, there was solid- and liquid-state oxidation of the Al alloy. The solid-state oxidation exhibited strong dependence on the density of surface defects on the Al-alloy particles formed during milling. Higher milling efficiency resulted in less participation of the Al alloy in reaction-bonding. This was because of its consumption by chemical reactions during milling, and subsequent powder handling, and could be rather harmful in the case of over-milling. In contrast to very little dependence of oxidation of the Al alloy on its particle size after milling, the relative density, microstructure, and flexural strength were strongly dependent on particle size after milling (i.e., on milling efficiency). The relative density and 4-point flexural strength of the RBAO ceramics in this study were ~98% and ~365 MPa, respectively, after post-sintering at 1,600˚C.
참고 자료
없음
"한국재료학회지"의 다른 논문
더보기 (2/7)