환경하중에 의한 연속철근콘크리트(CRCP) 종방향 철근의 구속정도
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국도로학회
ㆍ수록지정보 : 한국도로학회논문집 / 16권 / 6호
ㆍ저자명 : 남정희, 안상혁
ㆍ저자명 : 남정희, 안상혁
영어 초록
PURPOSES: The purpose of this study is to evaluate the degree of restraint (DOR) of longitudinal steel at continuously reinforced concrete pavement (CRCP) against environmental loadings. METHODS : To measure the longitudinal steel strain, 3-electrical resistance and self-temperature compensation gauges were installed to CRCP test section (thickness = 250mm, steel ratio = 0.7%) and continuously measured 10 min. intervals during 259 days. In order to properly analyze the steel strains first, temperature compensation process has been conducted. Secondly, measured steel strains were divided into 12 phases with different events such as before paving, during concrete hardening, and after first cracking, etc. RESULTS : Thermal strain rate (TSR) concept is defined as the linear strain variations with temperature changes and restraints rate of longitudinal steel against environmental loadings (especially thermal loading) with different cases is defined as degree of restraint(DOR). New concept of DOR could be indirect indicator of crack width behaviors of CRCP. CONCLUSIONS: Before paving, DOR of longitudinal steel is almost same at the coefficient of thermal expansion of steel (12.44m/m/℃) because of no restraint boundary condition. After concrete pouring, DOR is gradually changed into -1 due to concrete stiffness developing with hydration. After first cracking at crack induced area, values of DOR are around -3~-5. The negative DOR stands for the crack width behavior instead of steel strain behavior. During winter season, DOR reached to -5.77 as the highest, but spring this values gradually reduced as -1.7 as the lowest. Based on this observation, we can presume crack width decreased over time within the time frame of this study. This finding is not consistent with the current theory on crack width variations over time, so further study is necessary to identify the causes of crack width reducing. One of the reasons could be related to concrete stress re-distribution and stress relaxation.참고 자료
없음태그
"한국도로학회논문집"의 다른 논문
- 지형 선형 연결 설계8페이지
- 도로 설계 지역 구분9페이지
- Superhighway 연속곡선의 설계 방침에 대한 연구11페이지
- AHP분석을 통한 도로 교통안전지킴이 로봇 개발에 관한 연구9페이지
- 판별분석을 이용한 고속도로 교량영향권역 교통사고 특성분석에 관한 연구10페이지
- 구조방정식을 이용한 문화예술의 거리의 가로경관 이미지 분석11페이지
- 차량시뮬레이터를 활용한 도로기하구조 조건별 CO2 산정 연구8페이지
- 국내 아스팔트 콘크리트 포장용 택코팅제의 기초물성 평가8페이지
- 하모니 검색 알고리즘을 이용한 피로균열의 포장설계 및 유지보수 시기 결정6페이지
- 연성포장설계의 소성변형과 피로파괴 예측모델에 대한 신뢰성 연구9페이지