FRP Hybrid Bar의 수지 경화 속도에 따른 적정 배합비 산출을 위한 실험적 연구
(주)코리아스칼라
- 최초 등록일
- 2016.11.02
- 최종 저작일
- 2016.09
- 6페이지/ 어도비 PDF
- 가격 4,000원
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국복합신소재구조학회
ㆍ수록지정보 : 복합신소재구조학회 논문집 / 7권 / 3호
ㆍ저자명 : 박기태, 김희주, 유영준, 이상윤, 서동우
목차
1. 서 론
2. FRP Hybrid Bar 소개
2.1 FRP Hybrid Bar의 재료적 특성
2.2 FRP Hybrid Bar의 제작방법
3. 수지 배합비에 따른 경화속도 검토
3.1 합성수지의 종류
3.2 합성수지 배합비
3.3 실험방법
4. 실험 결과
4.1 수지경화를 위한 경화제비
4.2 경화시간에 따른 적정배합비 제안
5. 결 론
REFERENCES
영어 초록
FRP Hybrid Bar, composite structures composed of synthetic resins, deformed bar and glass fiber, was invented in order to solve corrosion of rebar in reinforced concrete structures. In order to bond deformed bar and glass fiber to FRP Hybrid Bar, synthetic resins is used. Curing time of the synthetic resins greatly affect productivity. If curing time of synthetic resins is short, cost of facilities is reduced and productivity is increased. Also, If this curing time is shorter or omitted, FRP Hybrid Bar can be commercialized. So, it can cause mass-production and substantial economic effect. Therefore, in this paper, optimum mix proportion is observed in order to increase economic efficiency of FRP Hybrid Bar and reduce curing time of synthetic resins. Total 9 variables are set, adjusting ratio of hardener ratio, and 3 resin moulds on each variables are fabricated. Optimum mix proportion is suggested based on data measured by temperature sensor.
참고 자료
없음
"복합신소재구조학회 논문집"의 다른 논문
더보기 (5/10)